You should install special driver for Windows on 5054. as default the ODIS only have driver for W7,no for W8 /or W10
Please Guys,
I was struggling to install vas 5054a in windows10, so i decided to buy chinese vas6154 because itīs supported.
I installed it on a fresh windows10, only show me vas6154 and 6154a as hardware options.
After install, vas6154 hardware is not recognized by odis.
Searching in forums, i discovered vas6154 is a vcx interface. I got mad.
Please Guys, give me directions to make this shit working on windows10!!!
Thanks in advance
You should install special driver for Windows on 5054. as default the ODIS only have driver for W7,no for W8 /or W10
Hello. You have to install VX Manager ,last version, and do firmware update. I am using this chinese tool with ODIS 6.2. It is working, but not so good, it is loosing the connection with the car
any recommended good source to buy working vas6154 ?
Must work on Windows 10 ltsb with odis 7.x
thanks
You do not know what you are getting with chinese.
I got 6154 and ~~~~ing licence ran out 31/12/20
Would not update firmware or nothing.
Customer support says that it will still work!
Yeah if you set the date back to last year ffs.
Bought a Dialink passthru vci instead as it works on BMW and Xentry software also.
HaynesPro online + 2022.02a version available, message for where to get it!
Thanks
I do not care about license or the software that comes with it. I have one original VAS6154 and i can get fully legal license.
I only need a second one for some tests.
So info about any good sources for the interface?
Ok. Understood. Thanks
So i better go for a second original device.
Bookmarks