You need put more information for others can help, and how many mileage you want.
You need put more information for others can help, and how many mileage you want.
needs 91810 miles
Try to read the dump with an eeprom programmer. Must be 2048b.
i did read with eeprom programmer size correct but was crypted sorted now thanks all for your replys
Last edited by kiramine; 1st February, 2010 at 11:18 PM.
I don't think your dump is correct try reading again with 16 bit and post again with the original mileage.
Dump was fine if you read above post job is now sorted thankyou
Hi ,
One question, on the dump the milage position whose
....
Car type: Audi A3 - 93c86 - 2003 year
The mileage is stored in the next lines:
0570: xx xx xx xx xx xx xx xx 00 01 E6 28 xx xx xx xx
05D0: xx xx xx xx xx xx xx xx 00 01 E6 28 xx xx xx xx
where the next bytes:
00 01 E6 28 - is a mileage
....
and waht i see in the dump is D1 3A B9 D5 and 37 65 58 7B
What i make wrong?
Above dump is crypted so tachosoft location no good !!
Hi,
can You explain this "crypted" better?
einet
load file in this proggy all will be explained remember cluster is in km not miles
Last edited by kiramine; 2nd February, 2010 at 07:26 PM.
hi what programmer did you use to read/write to this eeprom
i have same problem ,and bought r250s programmer only to find i need an r200
so my only option is now to remove eeprom and buy programmer
any help would be appreciated
Last edited by hollow; 11th February, 2010 at 12:05 AM.
Here it is with corrected milleage.
Regards
anyone help ?
everytime i try to dump eprom file size is correct but with the above program it states this dump is not supported ?
has been read in 16 bit mode nd 8 bit mode with no difference .
I have a couple of old dashes to experiment on - but what is the best choice (not too much cash - Please!) for a programmer? Help!!! - Thanks!
Bookmarks