fred77 (18th June, 2021)
Anyone ever met such problem?
Car came for spare key. No errors on dash runs all ok.
Hooked up few tools no pull pin. That orderred pin ,try program saus wron pin. But pin is ok 100%
So error noticed only in end when tried hook up diag tester to scar for comms.
Just pluged in obd car went crazy,dash full of lights,whhen turn of car ir not turn off dash flickering ,black,but engine not stalhs. Pull out obd plug on runnig car,car shut off. Restarts all ok ,errors goes off. If connect tester back again christmas starting.
Hooked up 3 key tools no such errors. Only with autel
That noticed live voltage low on obd.
Tested 4.5v
Ground pins no ground.
Owner bough car is 2000km from resseler but totaly new . They say no aftermarket instals as resseler took from dealer. But i found non factory wires with fuses under hood,also to bcm.
Video
https://youtu.be/qMMteizQSlk
Renault ECU tool / IO terminal / A.S.W
fred77 (18th June, 2021)
Yeah I seen issues with other tools and cars. we don't know the multiplexers fitted in these scan tools or the car itself what non-standard OBD pins may be used for.
Know OBD covers pins 4,5,6,7,14,15,16.
Expect in your case Autel interrupted CAN lines. causing stuff to light up!
------------
On another note would u know why i have no comms to a smart unit on a 2019 sorento
used g-scan
Solidarity with Ukraine
But why on obd port pin 16 only 4.5v and no grounds? Its fir sure a problem. It cant be wires mixed up from factory power and ground un diferent place.
Renault ECU tool / IO terminal / A.S.W
Check is it ground problem or +12 problem
and then add proper gound or +12 to the OBD
I checked its both.
16 pin 4v tested on chassis ground.
Obd ground pins totaly no ground if test continuity to chassis.
No matter not my job,car not local, owner called seller maybe they fix something. Not wanted dig wiring etc as already experienced that if you try help look fir fast solution and no go,later seller can argue that all was ok you blow it etc. Better walk away
Renault ECU tool / IO terminal / A.S.W
You be surprised...dont trust a word..2019 could had dash out etc..
If you have 4v on 16 and no ground this car is definitely mess...
I would stay away from it..
Sent from my SM-G955F using Tapatalk
Auto Locksmith,Tuning,Dpf Removal,Dtc Removal,Immo Removal,Ecu Adaptation,Crash Data-Clear.
yeah better to walk away sometimes
Solidarity with Ukraine
I've seen alot of trackers that ties into OBD with a split type harness ... they remove original obd then plug into tracker harness then put tracker other end of harness where original obd plug goes...
Solidarity with Ukraine
I asked them about some adapter in split. They dont know nothing.
Renault ECU tool / IO terminal / A.S.W
maybe this will help in future
Solidarity with Ukraine
drugowaz (22nd June, 2021)
G-scan team has stop security support for Gscan tap for new vehicle. No support for key programming new vehicle 2018 and up.
Weasel3 (5th September, 2021)
Bookmarks