I found this on the web, it's from the developers of dashcoder, they used it for the x12 programmer tool. So it must work. There are two versions of the ZGW board, a short and long version, don't know which version this is.
I am totally not good with the HEX stuff but I try to learn.
Youcan reset all service entry's I saw also a tool for this, anyone tried this software?
Welcome to: DeJaVu uVaJeD -> support site
Hi,
Did you read this with DIGA clone?
Also I d'like to ask :
Is Diga clone works woth secured MCU in ignition or it not working.
Before an year i try one ignition wirh diga, but it not works for me, I made 4-5 tryes - same thing. I afraid not to burn or to loose data, so i stop trying.
Someone have experience with it? In manual there is written how to connect it and touching with wet finger, but is there anything else...?
Last edited by yasser; 5th February, 2010 at 02:50 PM.
Posted solution over here http://www.digital-kaos.co.uk/forums...47/#post446751
No need for dumps to clean up full ASSYST
For those who are a bit too lazy to solder and desolder - the Abritus tool can read the EEPROM of CGW units. This is how I do it. After I read the dump I load it in their CGW explorer and it shows some mileages, which I can not see in Star.
I have never tried it on a CGW from a W221 S-Class though - I know it is different from the others...
Where i can find a ZGW EDITOR?
Thanks
Bookmarks