Check CG100, all EEPROM's and many MCU
Please dear members push the button if my work was helpfull!
KESS 3, IProg, X-Tool, CG-100, GCPT, etc.
VAG-Com, KTS-530, Autel MaxiDas, Lexia and many other diagnostic tool's.
I am interested on it!
Eeprom cheapest ch341a. With some take long tweaks it works. Can read lots of them. Neoprogrammer.
xprog does all eeproms and motorola mcu
brend (25th July, 2022)
vvdi prog now also in good price.................much more stable as xprog
need help
now my goal is to buy xp-005
who will help?
UPA s is good i must say. Down side hasn't been updated for a while.
Plus side Rarely corrupts data.
And probably cheapest doing rh850 chips
Last edited by fuzz1; 26th July, 2022 at 09:38 PM.
To start the work with eeprom
You need also the following
A desoldering station
Heat gun plus soldering iron minimum cost around usd 50
Third hand with magnifying glass USD 10
Brass wool to clean tip
Desoldering wick
Solder
Flux
About usd 100 for everything cheapest i found but does the job
I have ch341, eeproms read write no problem, but i would like to learn more about programming itself, on which address what to change an so on...
I guess if you want to start with programming then a good starting point would be the chip data sheets. They will give you the address
GQ4-X
Verry good tool
BR
Bookmarks