Try with the menu of A8, probably the old one. The difference amoung these two are the EPROM content which should not affect to the programming.
Try with the menu of A8, probably the old one. The difference amoung these two are the EPROM content which should not affect to the programming.
argg my programmer xprog-t just says device silence and also whit a hc11f1 mcu
I get device silent trying to read E59B MC68HC11KA4 QFP64, I have desoldered it and try to read it with xprog-t ,have also tried to read it in circuit, no sucess.
Have you sucessed to read any MCU with your xprog-t ?
Also if you read in circuit be shure quartz from pcb is same as xprog software settings! In other case you need to setting from xprog software!
With the xprog it came a adapter for for HC11A8/E1/E9/E20/EA9, could I use that for the KA4 ?
It has a 8Mhz crystal on it.
How do I check the quartz from PCB ?
Regards
Added a pic of the PCB in question.
Last edited by pinch; 16th May, 2012 at 07:46 AM.
no any luck there is a crystal whit the adapter there is follow 2 the device.. there is 7pcs adapter whit it ..
its this one i have
Telwis.pl: XPROG-T HC12/HC11/HC08/HC05 Programmer [FULL SET]
I have the same.
HC11A8/E1/E9/E20/EA9 is the only QFP64 adapter for HC11.
I dont know if it works for KA4
i have adapter hc11f1 and chip 2f37e its just says silence grrrrrrr
Try other programmer!
Last edited by emekelektronik; 13th February, 2010 at 08:08 PM.
oder programmer??
arg you mean Other programmer.. the first i have was xprog-m that dont work now this... and its not work eather
I didnt even get mine to read the X24C01 either....
is this programmer s**t ?
How many do you have to buy to get a working one ?
Have you managed to read anything with yours ?
Bookmarks