first try with older soft.
Google for pdf from AN2135 for power suppply
Hey,
I recieved a sonda and I supply 5v ic AN2135SC and now it asked for the CAN driver thing that never wanted before.Now is complet installed but can't make firmaware update it's stops at 20%.Does anyone know what supplys that IC?
Thanks in advance
Last edited by Claudiu_dar; 17th February, 2010 at 11:31 PM.
first try with older soft.
Google for pdf from AN2135 for power suppply
Hi all, i have a problem with my ISO function, but not with my can fonction because it was recognise. Do you know if i replace this chip AN2135SC it will work ?
Thanks for all
hi, thnaks for your answer, but do you think you can repair mine if i send it to you ? Thanks for all.
i work whith clip.works perfect
Thanks for the great information
Can anybody provide the good quality picture of the 2nd board.
It seems some Clips are broken by the defects of power supply line, rather than AN2135SC itself.
I think I am missing some elements on the 2nd board.
Hi rtvservis
I have bough from china a Can Clip last year.I used it two times just on cars nevest like 2000 and it work.But the first time I uset on older car(Laguna-1998) do not work.Then I move quick on my Megane II 2006 and it work.
After couples of day I must diag. a other old car Clio I and again not work.Again I muve to my car and work.
Please tell me what do you think about this.
Can bee software problem or hardware problem?
Thanks in advance!!!!!!!!!!!!
I had the same problem,but when I wroted the VIN the application doesn't go further .
The problem was from soft ,I used partition magic ,I hided a partition and put a new windows on that partition and only Clip without anything else installed and now is working
THANKS
I have problems with my clone clip. It will not read the vin (stops at 98% & reports error), it did the first time I used it. I think The firmware update in v95 is the culprit. Also when attempting reprogramming it would ask for the clip software serial no. I don't get this now. When I attempt reprogramming it scans & stops with 'disconnected' If I try consult a computer it gets to the approval no. request & that's it. I have tried this on two Espace v6 2001. Am I stupid or is this a fault? Is there anyway to backup the firmware or update the chip that will work with the latest firmware updates.
HI.
I have same problem with a ORIGINAL CLIP ( not china ).
I change it AN2135SC and same error...
I dont know whats happened. Maybe need to change other IC?s ?
Thanks in advance.
Regards
Bookmarks