Hi guys i have an issue with my clip. Booster pack on car fried my clip so i replaced the 2 quartz and 2 AN2135 on both boards. Now i have firmware update (renamed files in directory) and all leds light up on clip. I can read the vin number from a 2013 traffic but cant detect any ecu on network test. Any help would be great. Thanks
Med01 (26th December, 2015)
Check CAN SJA1000 chip and relay next to it.
thinks to all
not work with my clip
update err
plz help me
best regards
I have renault can clip V153
and when i using it to make a test for my car it's suddenly disconnected
and then it's begin to work again then disconnect and so on.
so what can I do. in this case
Hello Pro Friends
I would like to buy a clone Clip
Any one advice me which one i should buy
I heared that there is Clips with RLT 2002 and others with alliance drivers Boch
Please need advices and how i can know the right one
Envoy? de mon SM-N9005 en utilisant Tapatalk
Hello friends
Envoy? de mon SM-N9005 en utilisant Tapatalk
thanks to all for sharing
my clip not work plz help me
best regards
Hello,
I have a Clone Clip too.
My Problem is , a newer Megane III with Multiplex Can works fine.
But older Twingo dont.
And when i take not Renault --> Scantool ISO 9141-2 and ISO 14230-4 it didnt work.
In my Computer there is only one Bosch Automotive Service Solution Device --> 1B-Alliance Vehicule Communication Interface
Hello,
I'm french, sorry for my english...
I have a not bad clone can clip V127 with AN2135sc (with 2 green leds on) (automatic VIN is ok ). But it's not possible to update to actual firmware to V154. block to 74% (and 20% on other old clip version V132 for example).
I would like to know if its a problem on pcb can or iso. when can clip receive a new firmware, what is happening on pcb. Is it 2 firmwares ? one on ISO pcb and 1 on CAN pcb ?
is it possible to load firmware manually ?
any information are welcome
Yann
Hi guys, I've read this entire topic and I will try some things (mainly the oscillators), but still have a doubt related to my Renault Can Clone. The ISO green led isn't on. What could be the main reason for that ?
Thanks
Hello
my Can clip not work iso light not on or binking
and 2 transistor or mosfet missing instead of diode! 2 normally diode solder by factory
which one mosfet or transistor 2 missing???
regards
Bookmarks