RENAULT CAN CLIP REPAIR SOLUTION

[eiemax]

I can change my flash memory with other empty, or i have to put some file in this new memory?

Thanks

[baner]

You can use dump from your "old" flash chip, anyway it must be programmed before going back on PCB,
I think that those dumps are already posted somewhere in board.

Regards!

[Renaultmeg]

Good evening,

I have a CANCLIP probe, my four LEDS is lit(switched on)
But impossible to be entered diagnosis, bloquage on update firmware 20 %. And loss of communication and to verify food(supply).
What is are them constituent(component) to be replaced (if possible in photo?)
Thank you

[amir_82013]

I install version 131 clip good but after a few days for opening software give me Error 15024 and 15028
What is problem ?
i check Interfaces = Good .
LED Interfaces = Good (Green and Red) .
Cable: USB & Prob = Good.
install again software = but not solved problem.

Please help me. it now can't connect to car.
Thanks.

[Manuelgb]

hi
I have a CAN clip,
I do not detect modules, he says low battery
I start the engine and if I reconose all modules
you can help me that is?
greeting

[maldacenah]

Hi

I was a ISO led problem, and i solved making a jumper in MCU 1 and 132 pin to send the signal on to the rest of ICs.
ISO board start now but 20% firmware error. Before this I see in Strobe pin of LM311 I have 12v is that correct? I remove the IC and test in board and 0V IC pins there is no short circuited. is LM311 faulty?

thanks

[Tusznioo]

Welcome.
I also caught up with green LED fault ISO disabled.
what is already done:
Replacing AN2135
Replacing the oscillator 32768khz
Improving connections
HOT-AIR heating

but the green led ISO off, the program does not see the probe.
You can help give you some ideas on what else can I do?
Thanks in advance for any help.

[morfej]

Check that big protection diode.... and check if you have than powersupplys on ISO board.

[peko]

hi friends

i have always message about clip interface deconexion

anybody have this message also ?

[peko]

Hi friends

my clip lose communication lot of times, during scaning DTC

i doubt about quartz, but maybe anybody know and solve this trouble

thank you

[aitistu]

Hi friends

my clip lose communication lot of times, during scaning DTC

i doubt about quartz, but maybe anybody know and solve this trouble

thank you

hi, did you check obd to clip cable with multimeter? i would start there if you can reconnect
if it's not cable, then open interface and resolder the round conector pins to clip board
regards ,
c

[andkl2810]

Full Flash AM29F800BT for ISO and CAN block . Read today , before my clip ISO light off ..... add two eeprom ...

[aitistu]

hi,
i have clip 96 clone, and want to upgrade. any sugestions for which version are welcome
thank you

regards,
c

[andkl2810]

Вирішено! Led ISO На ..... 3 дня перевіряються всі компоненти ....: Відскік: Best Regards !

[Manuelgb]

[Quote = andkl2810; 2266313] Вирішено! Liderados ISO На ..... 3 дня перевіряються всі компоненти ....: Відскік: Saludos [/ quote] hi ?



hi
What is the malfunctioning of this resistance?
greeting