520d G30 SCR off on MD1

[atomiczen]

I need help disable scr on a bmw 2018 G30 520d with bosch md1cs001 ecu
i tried 2 swiftec solutions with no luck, car don't start anymore with no more km available on dash.
Is there here someone have working solution? i know bitbox and some other have solution for this. I don't know if someone have tested with success that
here ori file

[Blabla76]

You need professional help.

It is not always worth writing a file

[pike]

Hi,

with original file start ok?

[AKH84]

Hi,
try my file and report

[KIMICE93]

hello

pass in pm, TRY AND REPORT please

[JPerformance]

I dont understand why all post file with "try and report".

[atomiczen]

I dont understand why all post file with "try and report".

probably because solution is new and a lot need to test solutions, and it's not simple to have a car to test without the customer that break the ball at phone.

[atomiczen]

Hi,
try my file and report

hello

pass in pm, TRY AND REPORT please

both made same file. I let you know tomorrow

[eggystar]

RESET ALL SERVICES , OIL , EMISSIONS etc , Car will cranking , If not i have tested manual solution

[atomiczen]

Hi,
try my file and report

file seems work, 2 days without adblue warning, stranger things is 2 errors appear after driving test that never seen before
274000 fuel temp sensor and 284400 exh gas temp
removed dtc and car still working (is a taxi)

[pike]

file seems work, 2 days without adblue warning, stranger things is 2 errors appear after driving test that never seen before
274000 fuel temp sensor and 284400 exh gas temp
removed dtc and car still working (is a taxi)

it can't work

[atomiczen]

it can't work

you are right, it don't work
still adblue countdown

[Lambda1]

because swiftec and other automatic solutions dont work...
You need a manual one. Nobody will do this as freeloader job.

[atomiczen]

because swiftec and other automatic solutions dont work...
You need a manual one. Nobody will do this as freeloader job.

i know, i don't ask for free solution, i know that it's a new manual solution and need to be paid. My friend pike did it for me. i'm testing