immo off citroen xara

**chakir** · 15th February, 2010, 02:11 AM

hi friends , pleez i want make this dump im*o off

citroen xara 2000 hdi
BSI :Bosch EDC 15C2 0 281 001 782 (eeprom 95p08), what is equivalent of (95p08)?
thnx.

**marassa** · 15th February, 2010, 02:36 AM

tray this and confirms

**chakir** · 15th February, 2010, 04:27 PM

Originally Posted by marassa

tray this and confirms

for make this bsi code off we must programme also 29f400 chip or only 95p08? thnx

**melcool** · 15th February, 2010, 04:58 PM

Originally Posted by chakir

for make this bsi code off we must programme also 29f400 chip or only 95p08? thnx

only ST95P08!
Not sure but I think is like 95080 ... both 95080 and 95P08 start at 0 and end at 3FF...only try!!!

**chakir** · 15th February, 2010, 05:18 PM

Originally Posted by melcool

only ST95P08!
Not sure but I think is like 95080 ... both 95080 and 95P08 start at 0 and end at 3FF...only try!!!

I programme 95p08 with one dump the car start but the motor miss power where is probleme? wrong dump?thnx

i read eeprom 95p08 as st M95080 i found only FF FF FF ... (becauz i dont have 95p08 in labtool48 programmer)

**angmar** · 15th February, 2010, 06:37 PM

Hello use Upa Usb 100% ok
regard

**melcool** · 15th February, 2010, 07:15 PM

Originally Posted by angmar

Hello use Upa Usb 100% ok
regard

TRUE!
UPA has in the device list ST95P08
The pins are the same for ST95P08 and M95080 and the adress the same start at 0 and end at 3FF for 8 Kbit

**marassa** · 15th February, 2010, 09:41 PM

you must programme st95p08 and flash
dont forget to reply

**prog123** · 15th February, 2010, 09:52 PM

yes must programme flash

**sergiodc** · 15th February, 2010, 10:03 PM

But if he reprogrammes the flash , he change the software also , I reprogramme always only the 95P08 when I do this in my workshop , the best way is to read the original dump , then to correct it , when I use another file , usually I have the fault lamp on and sometime I have power missing ( it doesn 't increase over 3000 rpm )

**easytech** · 16th February, 2010, 12:01 AM

If you replace the 95080 file you have to recode the injectors! So correct the original.

**melcool** · 16th February, 2010, 08:03 PM

Originally Posted by sergiodc

the best way is to read the original dump , then to correct it , when I use another file , usually I have the fault lamp on and sometime I have power missing ( it doesn 't increase over 3000 rpm )

100% TRUE
Make im*o off by original for Peugeot 306 Citroen / Peugeot EDC15 - 95P08C3 it will work TESTED!

and another thing I tried to read ST95P08 like 95080 and NO succes!even the pins and the size are the same! only 22 FF FF 22! So it work only like ST95P08 with UPA
I LEARN EVERY DAY!!!