if cem is with 2 cpu ...copy 2 cpu ....you must copy 2
H i all i need help with a Volvo V40 ...with original cem with mc9s12dt256...i loose dashboard...after i disconnect it it works again......
i clone the cem and gives me same problem and also remote dont working but car starts....... can anyone check flash to see if the file is correct ? or i should check something else ??
Thanks in advance...
if cem is with 2 cpu ...copy 2 cpu ....you must copy 2
flash and eeprom mcu secured ...use all wires ...if you use x prog use all wires ( xtal....etc)
I did copy both mcu's.... Car starts... Bit dash again turns off car still working
remote is working now ?
Check charging voltage......I had one similar charging too high and causing dash to cut out. Check for faults in all modules. Turn on ignition but don't start and see if dash stays on until the car is running.
Tools owned..... Kess3 Master, Bitbox, TGFlash, VVDI2 Full, VVDI Prog, VVDI MB Tool, VVDI Mini Tool, VVDI Key Tool Max Pro, VCX series for BMW Ford Mazda Jaguar Land rover VAG Toyota Volvo GM, PCM Flash + Scanmatik2, Lonsdor K518ise, Magic tank and every other piece of Chinese crap out there.
Remote on donor nop....
I will thanks
remote must work ....cpu form left is 9s12dg128b ? remote is in this cpu ....do you get error when wtite cpu ? do you have airbag light on with used cem ?
Bookmarks