Problem solved.
Now I can read/write 93C46.
Tomorrow I will test with MCUs, but obviously programmer is working OK.
Thank you all !!!!
anyone get EWS3 Kline to work? Im struggling, all i get is a flashing green light, and initilising.. iv got 15v power to. Clone btw.
Hi peaple ! thas anyone knows how to make the connections to 374 , 104 pins to x-prog divice ! and what usb- com shold y put x-prog 1 or 2 because whem i install the soft apears in (com 7) and at baud ! 9600, or mor ?!
thanks in advanced ?
regards !
Hi i did one 2L86D in the past, now i am trying my second one and when i press read i get DEVICE SILENT.
Please help
So i did it, problem was with the drivers, i dont know why but i just had to reinstall them. Remember i am using the original tool just for reference.
Regards
locks85
I had a lot of issues with "device is silent" when reading large MCU's, I was powering it externaly with a 12v 1.5 amp power supply.
I swapped it to a 19v 3.4amp power supply off my laptop and it worked 100%.
do you do that even when the software says it wants a 15v power supply fallen?
By the way, I just used your tms370 guide, it was very helpful, so thanks!
Mate, I didn't have a 15v power supply handy, I figured a few axtra volts wouldnt hurt right...
I bet it even made it work faster!
Glad to help mate.
I have XPROG 4.5 M with Atmega64 damaged how can I copy the ATMEGA64?
Thanks to all
Get a UPA Programmer aswell buddy.
UPA is perfect for 93c46 where as X Prog-m is perfect for other types of chips like 2D47J. The UPA has the adaptor board for the 93C46, just solder it on and plug it in and your done, X Prog is not so easy with the 93c46.
Its best to always have a UPA and a X Prog-m.
Bookmarks