VW EDC17C46 resistir value

[Sarkan]

Does anyone know the value of this resistor that is marked. VW Sharan EDC17C46.
I measured a value of about 560K ohm but I think it's a too big value. After soldering the pins the engine will not start.
I doubt the resistor because every other measurement gives different results

[Sarkan]

I managed to solve it, after a bit of experimentation.4k7 is the appropriate value.
If you are reading from fgtech, you have to solder a few points.
I had to disconnect and connect those points several times and probably the resistor was damaged by heating.
The ECU remained in boot mode if this resistor was down.
If you try it on the table, when in boot mode it consumes about 140mA , if not about 350mA.

[andkl2810]

HI !

2,6 kOm