SOMEONE SOMETHING
Hello. I am asking you to check the correctness of the read file and to remove the accidental data..........
89170-50M10 CRASH.zip
Last edited by autopiotronik; 11th August, 2022 at 10:20 AM.
SOMEONE SOMETHING
Is car there or not?
Yes, I have this car. And after cleaning I have a returning error B1163. I can see that this is a fairly common problem with these drivers. Is there any advice? So far, the car is ready for driving, only this light is on.
upload your clear file
Not good ........ I read the codeflash and then wrote it down and I have no communication on the car
autopiotronik (13th August, 2022)
Thank you for your interest in my problem, but I can see that it is a coincidence.
I always tried to read (data flash, code flash, user data) for safety, if something went wrong. I have IPROG + and I am actually gaining experience on it, but I only have problems with this processor. Recently I also made Lexus and I had the same situation and I do not remember how I did it, but after great adventures, finally uploading the codedata, the module worked. But I do not remember how it went. And here's the same. I think it's a problem with writing because then there is a bad data verification. or something else. And besides, what makes the b1163 error, but by the way, because so far I have a dead module. Could you advise me something specific.
b1163 error is clear bad,first you need solve the communication problem.
Exactly, but how?
now it have communication?
I haven't done anything since then no communication
You can use Infineon memtool to rewrite cflash attempts.
Bookmarks