hello friend. test this one.
hi i have carprog and it says required update is not active under the airbag/nissan section. i was able to read the chip in the epprom section but i do not know what data to zero out, could someone rest the bin for me i would appreciate it.
2015 nv200 98820 3LM0B 95128
Last edited by swa513; 14th August, 2022 at 05:20 AM.
hello friend. test this one.
swa513 (14th August, 2022)
thank you for your help i will try it out asap
your tool read bad......
Use good tool read it or check your welding.
i dont know how his can clear it....
Last edited by superjet; 14th August, 2022 at 03:13 AM.
Your clear file.
report.no report no help next...
pass in your pm.
swa513 (14th August, 2022)
thank you i will let you know some time today
i just tried this and it gave me a code b1239
Crash is gone,you need check wireline or other parts without srs module,clear file only clear crash,no clear all dtc!
swa513 (15th August, 2022)
i appreciate your help i really do not know much about this stuff. before i flashed the module i had 4 codes B1209 frontal collision detection, B1035 crash zone sensor communication fault, B1051 driver airbag module circuit short to ground, and B1056 driver airbag module GND-short.
now it only has the one B1239 control unit and my autel unit does not give any specifics that it may be. i just got this van 2 weeks ago and the previous owner bought it rebuilt and drove it 5 years with locked seat belts and no front crash sensor the wires were just cut off. i fixed the belts with parts from junkyard seat belts (it did also have codes for both belts before i fixed it last week) and i got a front crash sensor from the junkyard from a versa with no body damage which is supposed to use the same part and soldered a connector on the wires. i will check the wiring tomorrow thank you
B1239 control unit?
Try this one,same pass
swa513 (15th August, 2022)
when i click on the link i get this error from the site
You are not logged in or you do not have permission to access this page. This could be due to one of several reasons:
- You are not logged in. Fill in the form at the bottom of this page and try again.
- You may not have sufficient privileges to access this page. Are you trying to edit someone else's post, access administrative features or some other privileged system?
- If you are trying to post, the administrator may have disabled your account, or it may be awaiting activation.
i just tried the 2nd one and my scanner can not connect with the airbag module, it cant read codes and the airbag light is on.
Bookmarks