What programmer did you use for read/write?
Hiya can someone help me with my subaru xv 2013 .. eeprom damage ( 93c76AD ).. tried to lower the mileage. then its not sync with my BCM / .. need my mileage 105000
was using ezp software (SUCKS)
gas indicator not working,
blinking temperature indicator
immo warning light appear
What programmer did you use for read/write?
subiexv (18th August, 2022)
i write using ezp (which is a big mess) . i read using vvdi..
your file is totally corrupted
IF MY POST WAS HELPFUL DON'T FORGET TO GIVE ME LIKE AND REPUTATION... THAT WILL KEEP US HELPING OTHER'S
subiexv (18th August, 2022)
Can somebody help me ..
What is the original mileage? I will check your original file later. Try writing the original file with some other programmer, for example Orange5.
it was 184xxx or 185xxx .. but after corrupted I tried to put back the eeprom .. it shows 371XXX KM or 317XXX , gas indicator not working, temperature indicator is blinking red and blue..
attached is another one .. I wrote back on my eeprom .. seems no problem, gas indicator is fine, .. but only immo locked warning couldnt start.. (109698km)
Last edited by subiexv; 18th August, 2022 at 04:12 PM.
If you compare the original dump and the donor dump, you can see that in the original two adjacent bytes are the same and this should not be so. Probably due to poor contact in the socket, there was an incorrect reading of the dump. And since the chip has already been rewritten, I think it's impossible to return everything to its original state.
the donor is working .. its just immo warning.. can you sync it with my bcm? I can get the mcm dump to match with the eeprom cluster
Bookmarks