so, just started learning on scrapeyard modules, and the problem i encounteris that the eeprom is glued because of the conformal coating on the pcb and wont come of, just with extreme heat that would damage the eeprom, also i managed only by breaking the pads using an exacto knife to pry up the chip.
thanks.
whats your take on this modules?
Results 1 to 2 of 2
Hybrid View
-
3rd November, 2022, 01:09 PM #1Newbie
- Join Date
- Jun 2022
- Location
- ROMANIA
- Posts
- 15
- Thanks
- 8
- Thanks
- 0
- Thanked in
- 0 Posts
conformal coating on cas,fem airbag etc
Last edited by encor4; 3rd November, 2022 at 01:14 PM.
-
3rd November, 2022, 04:08 PM #2DK Veteran
- Join Date
- Jul 2019
- Posts
- 3,543
- Thanks
- 2,024
- Thanks
- 820
- Thanked in
- 557 Posts
Hi
You forgot to give more details on what specific modules you got issues.
What temperature are you using to desolder?
Try with some flux and 450 degree C. Just move the heat gun around it should work.
Else solder wires on the eeprom legs and remove the capacitor to prevent it from powering on
Reply With Quote
Bookmarks