Hi,
Is it possible to flash atmega via COM port?
My PC is missing LPT.
Hi,
Is it possible to flash atmega via COM port?
My PC is missing LPT.
My programmer on COM not working ok. But I use PCMCIA-COM. If you have native COM, maybe work fine.
So, I use or LPT simple programmer with Pony Prog Or USB AVR programmer with eXtreme Burner.
For LPT i use PCMCIA-LPT with change of LPT port of PCMCIA in LPT1 and in ponyprog2000.ini in line LPTPorts write the real address of LPT port generated by PCMCIA (FFE0 and FFE8 to me).
Actually I have stationary PC. Is it possible to use PCI card if no possibility using COM?
t1tan1 (4th December, 2013)
...
same hardware and same software which I uploaded here long time ago.
GAL device is very sensible one and you need a very stable supply voltage for programming using this schematic. Otherwise it will generate a lot of troubles.
atb
Can anybody help me with those BL cables? Still can't to figure out how to bring them to live?
Dear VCDS users,
On summer 2010 I bought the blue chinese usb/kkl cable for vag.
I use the cable in a Polo 6N2 year 2001.
Cable works fine but I have a software question.
But first look at pic "Engine_01_g3133_LAMBDA_ZONE"
I describe you the print screen:
Here are displayed groups 031, 032, 033.
Each group consists of 4 zones (zone is the term used in ELSA for VAS5051).
For example:
In group 033 these are the zones:
Zone 1 = 0.0% Bank1 Lambda Control; Zone 2 = N/A Bank1 Voltage of oxygen Sensor; Zone 3 = N/A; Zone 4 = N/A;
In this print screen I might have values at least in zone 1, 2 not only in zone 1.
You can compare this with the Elsa printout of VAS5051 in pic "ElsaVAS5051Group"
In pink I highlighted the two values that "must" be present even in VCDS.
In red there are other information not shown in VCDS.
In all groups from 001 to 255 all Zone2, 3, 4 there are N/A.
I ask you if this is a problem or if VCDS can't show all the information.
Thank you.
Try with VagCom 311.2 and KG
Good luck
...
I'm agree with rsibiza - Khazama or eXtreme Burner ...cheap solution ...
Now depends by your budget what kind of tools would you like to have.
atb
USBASP AVR Programmer - $16.00
Very cheap,16 USD only and very reliable
Or even from ebay and a bit more cheaper
This is the one I bought a couple months ago and is exactly the same as the one Rsibiza said above.
51 AVR ISP Programmer Downloader USBASP ATMega ATTiny | eBay
The one I bought from ebay didn't come with the original firmware from fischl.de - USBasp - USB programmer for Atmel AVR controllers but, just in case, I backed up the one inside ATMEGA8 and I flashed with the original one.
I also found that the chinese firmware had a trouble when I tried to reflash powering up the programmer with the 5V from USB. But if I used an external power supply everything was OK.
Another thing, the ebay and the one Rsibiza pointed are not exacty the same hardware from fischl.de - USBasp - USB programmer for Atmel AVR controllers
These versions don't have the jumper for "self programming" and the jumper for "slow clock". They only have the jumper for selecting the power supply (external or USB). Remember that in my case I had trouble with powering via USB... but when I changed the firmware the problem was solved.
Bookmarks