Hello everyone.
Does anyone can kindly provide eeprom atmega162 VCDS908 PL version?
Hello everyone.
Does anyone can kindly provide eeprom atmega162 VCDS908 PL version?
I'll be interested that 908PL version as well, please.
Hi `
Remove STC chip. Will work.
H? folks , the VCDS 908 can works with old cars, it is 2x2 connector for AUDI , k and L line ?
thanks.
Yes of course.
Hi everyone, sorry for my bad english. I have question for xoom. I looked at Your pbc(lay) and I have not seen lables of cristals. Can You or anybody else tell me the values? I am new in car diagnostic. I tryed to make my own diagnostic board, but I don't know why it doesn't work. FTDI chip is working. Connection to the pc without problem(Ross-Tech HEX-USB.ept). But when I program all chip and run the vag, nothink is detected. Including K-line. Source of my board and dump is here. Pass is cumelsk.
It seems that atmel work, because the led blink and all crystal have correct clock(oscilloscope).
Can You help me to solve my problem?? or any uggestion what can be wrong?
Thanks to all
Finally i have found some time and made changes like suggested, after testing on car all went well, auto-scan completed without errors, long coding, basic settings etc...
I know that many times this issue was presented and explained however since changes in garage section this should be the new guide and tutorial for repairing vcds interface. Thanks again
I am seeking the tutorial how to program the cable. I have 812 version, to update for 908.
A time behind this tutorial was in DK but he/she resembles this it was moved away. Perhaps somebody still has this and he/she can share. thank you
To ivanxxx,
I hope I did it correctly. Question:content of the file for Gal16v8 is independent to version of VAG or is anyhow adherent to VAG. I hope I have dump for VAG 805. Maybe I can send to You my dump and You can compare my and yours files.
Tahnks for replay
if GAL16v8 is programmed correctly.. try to check connections for this chip .. (in my case i use socket for this chip.. and sometimes is bad soldering)
ok, i have problem, but I don't know the position of it. So, is any possibility to compare my files with yours(if you have the same dump 805)?? or can any body send me 100% working files(ATmega16 and Gal16v8)?? I need to check, that I have correct working files.Then I can search the bug on my board.
my email is thanks for help, petr
Last edited by PremierD; 9th September, 2010 at 08:15 AM. Reason: NO E-MAILS PLEASE
Bookmarks