VAG-COM/VCDS EVERYTHING

[mattydr67]

Mate the loader is for what version?
Please.
Thanks
Good luck

[LuisAndre]

Mate the loader is for what version?
Please.
Thanks
Good luck

for 10.6.3 version.

[esrodi]

Today I have tried to update my cable, but something went wrong and the atmega hasn't been programmed correctly. During the flash verification ponyprog showed an error, and the programming process stoped.

Then, I tried again to reprogram the atmega, but now ponyprog shows "Error 24" and I'm unable to do it.

What is happening? I think that atmega is blank. Do I need to use a HVP programmer to write it?

Sorry for my english.
Regards.

[LuisAndre]

Did you erase the avr first? you can't write on the flash without erase it first...

[esrodi]

Yes, I did.

[mattydr67]

for 10.6.3 version.

One more question please.
This will work with my 10.6.0 ft232BL tool?
Thanks very much
Good luck

[LuisAndre]

One more question please.
This will work with my 10.6.0 ft232BL tool?
Thanks very much
Good luck

Other users told me it works well with that cable... even with firmware 1.81.

[autochampion]

Well Works from 1.83 and BL as the chip

Other users told me it works well with that cable... even with firmware 1.81.

[mattydr67]

One question
Do I need to run the patch everytime or just at the first time?
Good luck

[bibkare]

I tried to download the patch even my AV NOD32 was deactivated but still keeps to delete it and warns me that virus was detected, anyone has the same problem?

[JetSet59]

"trojan detected" with Kaspersky but think it's was a false positive

[blackpirate]

I tried to download the patch even my AV NOD32 was deactivated but still keeps to delete it and warns me that virus was detected, anyone has the same problem?

1. haveing the AvV deactivated , it cant delete it!
2. the file its clean!

it just a false alarm caused by the protector!

scan it on virustotal.com

cheers L.A

[alex_SW]

if someone can confirm if it works with 912 interface....i have a 912 but right now i dont have car to test....

[KenshinPT]

One question
Di I need to run the patch everytime or just at the first time?
Good luck

WRONG INFO:
Maybe you already know the answer but you don't need to patch it everytime you open VCDS. xxxxx

But I only tested the cable without a car. I tested only plugged into a 12V power supply.

Regards


My bad... You need to patch everytime you run VCDS

[LuisAndre]

Maybe you already know the answer but you don't need to patch it everytime you open VCDS.

But I only tested the cable without a car. I tested only plugged into a 12V power supply.

Regards

No, everytime you start vcds, you need to run the patcher... because this patchs are done on the program memory and not on the disk. If you run only vcds, you may end with a dead cable...