VAG-COM/VCDS EVERYTHING

[alexm1]

I do not want to deny kolymer.s work, I believe that should work good, as you say, I just can not figured out what I doing wrong.

- hw46
- for fuses -see picture

[Kapten]

hello i have this old cable 12.12
will it work?
IMG_6576.jpgIMG_6577.jpgIMG_6578.jpg
FW Version : 1.92
HW Version : 0x44
Identification : ROSS-USA

[alexm1]

What is written on the marked area?
China?

[Kapten]

D79F8513A
1436XB059
CHINA

ON THE BACK
MCP2561E


MCP2515

[liviudiaconu]

Never work updated with "Atmega's methods"..
D79F...=NEC, NOT Atmel.

[Moldovan1]

I do not want to deny kolymer.s work, I believe that should work good, as you say, I just can not figured out what I doing wrong.

- hw46
- for fuses -see picture

1) I have write FF for lock fuses.
2) About calibration - I saw that people also write something here. I dont know because I use Xprog for update, and Xprog don not have this calibration window of course!

[alexm1]

For calibration I use FF...
I will try again with FF for lock fuses.

[real898]

Foto fuse bit to pony prog 0x44 - 0x46 please

[mpcb]

Hi all,

Please help me with some information's, please:
I have VCDS interface from attached pictures, during of SCAN process was displayed one error message: This function required licensed interface. I mention here never update the software and WI-Fi closed, I used only version 15.7.3.
I installed fresh copy of the software (15.7.3) but with the same error message.
My question is if the error message indicate one damaged interface and must be repaired?
If yes can you guide me how?

Thank you for your help.
1.jpg2.jpg3.jpg4.jpg

[Moldovan1]

Foto fuse bit to pony prog 0x44 - 0x46 please

Use online fuse calculators for this

[Moldovan1]

Hi all,

Please help me with some information's, please:
I have VCDS interface from attached pictures, during of SCAN process was displayed one error message: This function required licensed interface. I mention here never update the software and WI-Fi closed, I used only version 15.7.3.
I installed fresh copy of the software (15.7.3) but with the same error message.
My question is if the error message indicate one damaged interface and must be repaired?
If yes can you guide me how?

Thank you for your help.
1.jpg2.jpg3.jpg4.jpg

By flashing Atmega you can solve this problem. Show screen from @about@ window!

[mpcb]

Unfortunately I don't have fw for 15.7.3 sw, which version of fw I can put on the interface?
Or where I can found the fw for 15.7.3?
Thank you.

[Moldovan1]

Unfortunately I don't have fw for 15.7.3 sw, which version of fw I can put on the interface?
Or where I can found the fw for 15.7.3?
Thank you.

If you have Atmega on board (on foto for sure is Atmega162), then read this thread. You find here all information that you need.

[34260551]

Foto fuse bit to pony prog 0x44 - 0x46 please

0X44.JPG0X46.JPG

[real898]

thanks 34260551