VAG-COM/VCDS EVERYTHING

**sraj** · 25th July, 2018, 03:54 AM

Originally Posted by guyguy307

Hello for 18.7 kolimer loader work?? Or only chins 1.2 loader ? Thks

only chinese loader 1.12 works flawlessly without any glitches all my friends use them

regards
sraj

**dj2d** · 25th July, 2018, 09:20 AM

Originally Posted by sraj

please someone activate this loader chinese ver 1.12 18.2 english version

Here you are

**ericas** · 25th July, 2018, 09:13 PM

Originally Posted by alexm1

Try again with usbasp, check again mosi miso sck reset conection, power 12v via obd2 ,ground to usbasp too.
Use 0x44 dump.

Nop, not working... i have tried anything...

**HotSwap** · 26th July, 2018, 12:25 AM

Hello Guys, I'm new to this.
I have 18.2.1 VCDS with V5 loader and cable test ok.
My questions: where can I download kolimer 6.3 loader and do I need to flash cable firmware if it test ok with the software?

I was trying to modify some long codes for my A3 8v and software gave me error out of something....

Appreciate any help.

**kaalis** · 26th July, 2018, 12:32 AM

18.2.1 english? It will not work with 6.3or older loader.

**HotSwap** · 26th July, 2018, 12:50 AM

yes 18.2.1 English. What loader should I use in order for it to work?

**jan4** · 26th July, 2018, 06:27 AM

18.2.1 does not work with any loader !!
Go back to version 18.2.0 , same fuctions and that works with 6.3

**obd2cartool** · 26th July, 2018, 10:20 AM

Hi, 1.12 loader can not work beta 18.5-18.7, these two version work for NXT and V2

**dj2d** · 26th July, 2018, 10:29 AM

Originally Posted by jan4

18.2.1 does not work with any loader !!
Go back to version 18.2.0 , same fuctions and that works with 6.3

It works with chinese loader but not Kolimer's one

**jan4** · 26th July, 2018, 03:18 PM

Chinese loader without activation ??

Pleas give more info

**zapdus** · 27th July, 2018, 11:46 AM

Hey, I have read all this thread

I had about 10 non-working cables, now I have around 3 only
@hid3 helped me a lot as he has a lot of knowledge on this
One of them I connected power wrongly, other should be like fuses problems or else
Always the same thing, check if your cable was programming pads for ATMEGA pins
If not, just solder 3 wire to MPC and 1 wire to reset pin ATMEGA
If you have programming pads just connect wires with female jumpers and USBASP