post your file
taxi300 (2nd June, 2018)
checksum is corrected?
Hello mates ,
I have the exact same ecu 8GMF on a Punto Evo 1.4 and i need DTC off on the P0512 fault .
Is it possible on my file too please?
Thanks in advance
never done it but should work
2WD Dyno , Magpro2 X17, FLEX Master , KESS Master , AUTOTUNER Master, Byteshooter Master, EVC Winols Reseller
Official Magicmotorsport DistributorCode:FILESERVICE: Tuning / DPF / EGR / Adblue / DTC / Immo
Official Autotuner Distributor
Official Alientech Distributor
Thanks for the file friend
But i programmed it ,, and now Start Stop function not work anymore ,,,
In Live data ,, check engine light value is Flashing . But on dash the check is off. Maybe that's why start stop not work ?
try this file
2WD Dyno , Magpro2 X17, FLEX Master , KESS Master , AUTOTUNER Master, Byteshooter Master, EVC Winols Reseller
Official Magicmotorsport DistributorCode:FILESERVICE: Tuning / DPF / EGR / Adblue / DTC / Immo
Official Autotuner Distributor
Official Alientech Distributor
Not work friend ,,
DTC pops up again and i get DTC U3FFFFFF now .......... for some reason dtc comes up now but not as P0512 ....
I think solution not good
Willing to pay for the solution
Maybe a little late, P1300 is not an error but it means Phonic wheel relearn. It is a sync between camshaft and crankshaft.
This should be done every time after the battery has been disconnected or the trouble codes are erased.
Warm car up, wait until cooling fans have run twice
Depress throttle 3 times until engine is at about 6000 rpm
When decelerating keep the engine rpm above 1200 rpm
Sometimes you have to execute this procedure a second or third time.
Mate it's not P1300 it's P0512 (:
As for the phonic wheel relearn ,,, every time i program a file on the car it for sure needs this and i perform it! It's been crazy revving up this Punto all day yesterday
Bookmarks