stevan (27th March, 2018)
stevan (27th March, 2018)
Yes my flash and eep are totally corrupted.Will try your eep rep.
not good EEP,still not possiblle to enter in 25 and in 17 control unit faulty error.
Anyway i have put ok eep from other 932N ver 1.50sw and made immo block generated transponder.
Because car was not able to bring here in Bosnia in my service i have transfer it to friend in Croatia-Zagreb to finish adaptation with PCR2.1.
Tanks a lot lupu sandu and pandokrator for help.
Hello, can you help me fix a file corrupted after a counter correct. Xprog read out 8P0920932N.
Last edited by tomek01; 9th September, 2019 at 11:47 AM.
post flash from micronas ! not eprom
the read set is attached
micronas 3217 flash ok
tomek01 (14th September, 2019)
hello,
i have question ...
i want to change my dash from 8j0920930c 2007 to 8p0920932Q 2011 ( i want to use oel gauge) micronas and 24c32
so i read out the flash and eeprom from the new(used) 8p0920932Q...with x-tool
with svci 2018 clone i read the flash and eeprom file, change it with old immo data and km and write back the eeprom with xc341 programmer...
but with the new used dash the car do not starting...(1 sec.).
no error in the dash (like def or safe) but if i pull the right button of the dash it shows
0/0 keys ... what is wrong ?
thanks for helping...
somebody can help me ?
thank you
Hi everyone, I'm new to the forum, I have a problem with my a3 my 2011, after changing the eeprom for staging hands and rs3 menus, the start and stop information no longer work, can someone help me please?
thank you
Post org and eprom with change .... or u try with org ? Ssa work ?
Have issue with micronas - can pm us please? Thanks
Need good flash and eeprom for 8P0920932N white cluster? Someone can help?
Post your dump
Last edited by evgeny87; 11th September, 2021 at 06:51 PM.
Bookmarks