Hi valued members
immo off and 120 ohm problems :
I have an ECU on my bench for immo off with emulator
MB Sprinter W903
2.7 CDI
Automatic transmission
EDC15C6 CR2.xx
I'm using clone Julie immo emulator incl 120 ohm resistor on board, for CAN cars.
Have desolder the eeprom 5P08C3, and read /write as eeprom 95P08 (I have genuine uupa-s programmer and genuine vlada@2019v3 adapter)
Then I have changed the value in HEX editor :
01D0 to 01D4 = 02 02 00 ff ff...
So far so good...
In the Julie manual it says:
" if you are installing the emulator in a car with automatic transmission, solder 120 ohm jumper on emulator and
insert a 120ohm resistor between Can lines "
I can't find where to solder, or insert the 120 ohm resistor between the CAN lines!
There's same on China SQU 80...
Someone done this? I can't test it in the car now..
Looking forward to any answer
Bookmarks