Reply With QuoteDump is ok, tango :
vaneodump.jpg
Results 1 to 5 of 5
Thread: VANEO not recognized keys
-
25th May, 2020, 02:06 PM #1Member
- Join Date
- Nov 2009
- Posts
- 92
- Thanks
- 20
- Thanks
- 6
- Thanked in
- 6 Posts
VANEO not recognized keys
ANybody may check dump ?
i tryed add pcf7935 with gambit - the same
with protag - the same
tango i havent lic for gen keys
there after programing i need close transponder?
no errors in module
coil tested 7 ohm
-
25th May, 2020, 02:58 PM #2Member
- Join Date
- Oct 2017
- Posts
- 55
- Thanks
- 103
- Thanks
- 9
- Thanked in
- 6 Posts
-
25th May, 2020, 04:03 PM #3Member
- Join Date
- Nov 2009
- Posts
- 92
- Thanks
- 20
- Thanks
- 6
- Thanked in
- 6 Posts
OK THX
What function is under TAB - key with loupe? this is for checking position key in dump?
-
28th May, 2020, 08:02 PM #4Member
- Join Date
- Nov 2009
- Posts
- 92
- Thanks
- 20
- Thanks
- 6
- Thanked in
- 6 Posts
ANYBODY may help with closing transponder?
-
1st June, 2020, 06:12 PM #5DK Veteran
- Join Date
- Nov 2009
- Location
- Minsk, Belarus
- Posts
- 714
- Thanks
- 58
- Thanks
- 290
- Thanked in
- 205 Posts
Hi friend! After any keymaker (Gambit, Tango, TMPro) not need any manipulation of chip: Chip ready to use! If You make chip manual You need write damp to chip and after its set password and config. Check its very easy: read chip of progarmmer. Original (and new making chip) read as same 8 string (81 01 to end). W168 and same car have many problemm of IMMO: Defect module, defect coil, defect chip, defect CAN, defect data (Chip-IMMO-ECM). Need diagnse of Star , need read actual data "Drive autarithation" in IMMO and in ECM.
Bookmarks