Yeah. to prevent the tube from inflating where you hit it. put a fiber. Remove the side pin to avoid damage to the locking and unlocking sensor.
Yeah. to prevent the tube from inflating where you hit it. put a fiber. Remove the side pin to avoid damage to the locking and unlocking sensor.
Should make key for lock door for old w124 in Monday. If no to late I can make pictures for you. Of course if customer come as he sayd.
Alpaholic (18th September, 2021)
today i make key for lock door at an old w124. hoere pictures how i do it. never fail.
hu 39.zip
6841707059 576F526B 57416E5453 596F55 526F6B69424152
Alpaholic (29th September, 2021), lesakljucevi (29th September, 2021), lion0304 (29th September, 2021), Manta1600 (20th September, 2021)
Thanks rokibar, saw it now, was on holyday. Will try that if the Lishi fails.
Last edited by Alpaholic; 29th September, 2021 at 12:20 PM.
Mad. Picked it in the wrong direction, now i can not turn it back. And lishi dont wanna come out. F..k.
IMG_2227.JPG
Last edited by Alpaholic; 30th September, 2021 at 05:57 PM.
Alpaholic (16th October, 2021)
I tried that, not possible. No bindings, its in the decoded status. And the taper of the first wafer dont let me pull the lishi out.
Last edited by Alpaholic; 30th September, 2021 at 07:51 PM.
Got it!! Its was just one single tip in the other direction. I was beginning to think of drilling the lock:-)
Last edited by Alpaholic; 30th September, 2021 at 08:20 PM.
Ouch!
A1=3, B2=1, B3=3, A4=4, B4=1, A5=2, B5=2, A7=5, B7=2
Wafer 6 and 8 not there.
That means B1, A2, A3, A6, B6, A8 and B8 are missing? Thats very much.
w124, Hu39. AKL, made a new key by dissasembling ignition lock. But missing A8 and B8, anybody knows is pos 8 half wafer or whole wafer in door lock, because door lock dont turn.
Thanks p1et, it was like that.
Now key turns in trunk and door, have no ignition here. So i dont know if it works. But i see on instacode that for this model i need a 6 cut. The only available lishi is a 5 cut. This cant be a good work.
Last edited by Alpaholic; 16th October, 2021 at 10:47 PM.
Its not a problem if 6 cut and tool only has 5 cuts , a little look at the 2 series and a little thought and its no problem at all .
when you look at the 2 series and 2 cutting cards , cuts 1 to 5 are the same depths on both series , so your 5 cut tool will read cuts 1 to 5 perfectly on the lines , cut 6 the new lowest cut will read well above the 5 cut line , same distance as cut 4 sits from the 5 cut line , so very very easy to overcome even with the 5 cut tool .
also on a 6 cut lock the 6 cuts wont need picking at all , the 5s will so another way of overcomming this.
ive decoded 6 height locks using the 5 height tool without issue , just needs a little thought and knowledge of the 2 cutting cards
…… deleted
Last edited by Alpaholic; 17th October, 2021 at 05:29 PM.
Bookmarks