518189_x800.jpg
On the front of the manifold between the motor and radiator.
Vehicle scan but does anyone know where this valve is located
Address 01: Engine
1 Fault Found
001632 - IntakeManifoldTuningValve Control Circuit (Bank 1): Elect. Malfunction
P0660 - 004 - No Signal/Communication
Freeze Frame
Fault Status: 01100100
Fault Priority: 0
Fault Frequency: 1
Mileage: 139318 km
Time Indication: 0
Date: 2020.02.17
Time: 15:45:45
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
518189_x800.jpg
On the front of the manifold between the motor and radiator.
teerak2uk (18th February, 2020)
teerak2uk (18th February, 2020)
Trying to do intake flap delete but continually get P0660 dtc
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
witch flaps are you deleting? the ones that change the length of the intake?
Can you unplug the electric connector- stop ecu seeing it and wanting it
#out of sight, out of mind
Was Banned For Being Certifiably Insane and Stupid
so have you unplugged the motor already?
you should remove the intake manifold and gut the plastic flaps, the you keep the motor plugged in, the ecu does not monitor its position, so wont throw dtc that way.
well in that case you can always do dtc off in one of the med9 ecus, maby even possible to put a resistor in place..
Bookmarks