Here Do not use any other method than this one!
kess alo had a older one which damaged a lot of these ecus
ENU_MO_0352.rar
Here Do not use any other method than this one!
kess alo had a older one which damaged a lot of these ecus
ENU_MO_0352.rar
antonypaul (4th March, 2015), garagetech (5th March, 2015), lucim12 (4th March, 2015), martinracing (18th May, 2020), overs0ull (4th March, 2015)
thank you!
here is my version
am I ok?
I belive that version of kess was not v2
anyways I am also going to read it with fgtech v54 just for safety..
i ment earlier version on the instruction manual, not of kess
2 ominimicu :
This method can damage ECU too (unfortunately tested by yourself ). Especially the one manufactured after 2.2014.
but i have never damaged a pcr2.1
back with reports
kess read it by obd ok, but at the end it gave a checksum error message, but the file was ok...
I put it on bench, did everything exactly as in manual checked everthing but it said no connection..
I did it with fgtech in the end..
check your fgtech tricore cable some have 2 wires inverted compared to original pinout
it worked well as it was...
since v1.89 software is old and many boot mode manuals are missing....
can i use newer versions on this HW or will it block NXp?
use up to k suite 2.06. of course internet always disabled
thx omi, but some reported many errors after using newer version..
is there any need for sd card files too ?
no, no need.
Bookmarks