try boot mode
try boot mode
HOW
Could explain me, please?
Try to flash it on the table, see attached docu.
Otherwise remove the flash and use a programmer.
Last edited by easytech; 15th April, 2010 at 04:33 PM.
i think you must open the ecu
read the memory and program it with original dump
it should be works
Hi.
As i know, a starting Fan is showing ECU is death.
Fan is Ground controlled by ECU,and errors during writing can destroy ECU's.
A Friend of me had this with a R32 ME7.1.1,this ECU can only be flashed by byteshooter with pull up resistor,or at table adding an resistor between some pins of 29F800,he did it usin MPPS on diagnostic.
After write failed,Fan startet.
Desoldered and replace 29F800,but no change,reflashed it and no change.....
I think you have same case.sorry
Best regards.
1:dismont ecu, program-it on the bench with original flash. the car will start!
2rogram-it with ,,tunned'' file on the bench (bdm100). older but best solution.
3:this are result of ,,chineese'' tools..
next week, i try to reprog flash directly and i post result.
Thanks
Yes,will start fans if ecu is empty.Open the ecu and desolder the flash.Hope you read the data before try to write new one?
If you have not ,write me pm with ecu ID and will send you ori.
Ecu location is -left side near to wiper-will need to remouve lft wiper to open the black box
OK
But i don't have programmer for this eprom.
I post result when i have solution for program this.
Serial programming tools will not recognise ecu,same as cloned galetto as original geletto will not recognise it.
The BDM100 is also the chinese name for a shitty cloned cmd flasher,because real BDM100 is designed for EDC16 ecu s not edc15,so it would not work on this ecu
Just a thought I got away with this a few times but not with this car . basically get another car like this and go in the system and prep vehicle for reprogramming and just as it is about to reprogramme swop ecus and program once it has sofware on it then you can reprogram properly to your vehicle eg vin,tune..........I am not saying it will work but it is worth a shot!!!
Fcuk up now............... ask questions later
PROBLEM SOLVED
I have reprog 29F800 with programmer and car start.....
Thanks
Bookmarks