cgdi dont works with w210 over diagnose port.only with programmer.also cgdi dont detect the 1 gen key.
actual they have many many problems with the sever.but the tools so far works ok.
cgdi dont works with w210 over diagnose port.only with programmer.also cgdi dont detect the 1 gen key.
actual they have many many problems with the sever.but the tools so far works ok.
figani (9th November, 2018)
Hello
When you did all key lost by OBD on b class w245 same as w169
CGDI Say unplug esl and connect the yellow wire to the Kline
I’ve read ezs with vvdi prog and make key it work
I didn’t understand
can someone tell me how to do all key lost by obd on the car ?
dear member in this forum i need your help,i want to know CGDI prog mb support FBS2,FBS3,all keys lost ???
USE GOOGLE !!!dear member in this forum i need your help,i want to know CGDI prog mb support FBS2,FBS3,all keys lost ???
please mate i just need help from forum not google because forum help is very strong
wphonetei (12th November, 2018)
thank you again tell me more what about OBD2 and bench
can work both , it depends on eis type
Yes you can read and calculate keys
darknezz19 (20th November, 2018)
Hi mates!
I programmed a BE key for W203 with HC908 EZS and I've got some problems. During driving the car, the consumers are powering off, the suction fan is working at max RPM and the faults:
B1025 The input signal 'circuit 15' is not o.k.
B1032 The input signal 'circuit 15R' is not o.k.
are recording on SAM-F control unit. I tried many EZS(2035450108, 2035450308, 2035450508) but always I have the same problem. The original keys seem to work good.
Is there any known compatibility issue between HC908 based EZS and BE china keys? I tried the VVDI keys and 2 batteries keys, always the same problem...
Best Regards
The keys are fine.
Replacing the front sam, should help.
Bookmarks