What difference beetwen KT200 and KT200 II?

[Thomas Smith]

KT200II ECU Programmer is better than KT200 in the following aspects:
1. New protocols have been added, and more and more will be added frequently in the future.
2. Fixed the automatic checksum problem of the first generation KT200, and the reading and writing efficiency has been greatly improved.
3. Many new virtual files have been added to the server.
4. Strengthened the protection of ECU, and will prompt you immediately if an operation error is made.
5. Optimized server access efficiency.
6.OBD reading and writing is stable.
7.Support DELPHI DCM7.24 ECU
8.Can work with htprog too
9.New automatic function:Tricore Clone


KT200II Read Write Bosch DQ380/381 OK
KT200II New cables available
Delco E38, E67, E84,E92
New automatic function: tricore clone.
Bosch 6L45, 6L50, 6L80, 6L90
Marelli 8GMC
Siemens SIM2K-305
Bosch MG1CA007
Delphi DCM7.24
Phoenix L40
TRW EMS2.4
Bosch EDC17 C11
Bosch MD1CS069
New cables available:
Bosch DQ380/381
998425

998426
998427

[carmageddon]

the difference is the box....and the color of pcb

[dimitar]

Same shit different packaging

[carmageddon]

i have it, is not shit if we speak about the job that can do...many possibility, stable tool, no problem for each ecu i did (also new ecu as md1, mg1, edc17, med17 etc)...the real problem is the "chip killer" inside that kt200 have (foxflash does not have it)....but soon the chip killer wont be a problem anymore

[arejas]

Deleted Post.

[arejas]

i have it, is not shit if we speak about the job that can do...many possibility, stable tool, no problem for each ecu i did (also new ecu as md1, mg1, edc17, med17 etc)...the real problem is the "chip killer" inside that kt200 have (foxflash does not have it)....but soon the chip killer wont be a problem anymore

What do you mean " Chip killer" ?

[carmageddon]

inside kt200 is present module soldered that made only one job : kill the cpu time based…and kt200 need to go back to china seller

[dimitar]

inside kt200 is present module soldered that made only one job : kill the cpu time based…and kt200 need to go back to china seller

Can it be removed????

[carmageddon]

maybe also…need some test

[maki]

What be problem if remove Chip killer,MCU block or not?
When be register new KT200II,you thinks old KT200 MCU erased?

[cardiagcom]

What about KT200 II still have inside chip killer ??

[carmageddon]

i'm wrong about the board inside the tool, is not chip killer, inside are the routine that allow the tool to start and work online...when grayed button Driver Selection mistake happen its only because this chip lost data to start and work...need only to change the board inside and tool relive...i did it on two tool, the factory sent me the board and i changed it

[dimitar]

Where do you get this green board when you need one?? Do the factory sells them or??

[carmageddon]

the factory has connected to my pc and did all test to understand why happen this problem and tell me that the solution is change the green board inside, i had two dead tool (i buyed many of this tool) and it sent to me new spare to solder