x prog m eror

[marassa]

heuy all frend i just bey chine clone x prog m V4.5 i tray te read whit it in dash kongo 99 with 68HC908AZ32A but whin read it it say device is silonce ..eror plz if sam one have solution for this

[morito]

hi

xprog is not good for 908 mcus is better etl or upa

regards

[marassa]

so what i can do for it im just bay it all member hier see x prog is beter than etl and upa ..

[Bishop c4]

Hi, marassa device is silent becausse need more volt. you need a power source of 15volt. and 300ma or little higher

[marassa]

hey bishop yes but win i tray to read with eny eprom all is ok jut in MCU it see device is silent.timeout error so must chang powr with hight volt ??

[Bishop c4]

yes marassa the reason is the mcu is more biger and need more volt power to work correctly try it and you see

Regards

[marassa]

ok frend i tray and i report thnaks so mutch

[marassa]

my frend i have ine 15v 500ma is it good ??

[Bishop c4]

the apropiate is 300ma find another for safety
we dont want to make a mess right?

Regards

[BimmerGT1]

heuy all frend i just bey chine clone x prog m V4.5 i tray te read whit it in dash kongo 99 with 68HC908AZ32A but whin read it it say device is silonce ..eror plz if sam one have solution for this


You must check the comport is not set correctly

Best regards

[knok]

heuy all frend i just bey chine clone x prog m V4.5 i tray te read whit it in dash kongo 99 with 68HC908AZ32A but whin read it it say device is silonce ..eror plz if sam one have solution for this

maybe you should lift some pins , like 2,3,26.

[marassa]

all the pine ar good just for powr ihave one for 15v 500ma is it good or not ??

[marassa]

hey frend im trey with power 300ma 15V not work ney change it see :device is silent.timeout error

[Bishop c4]

hello friend in that case you need to read all this tread
http://www.digital-kaos.co.uk/forums/f155/x-prog-m-54236/?highlight=x-prog-m
becausse the problem seems to be of another kind.

Regards

[marassa]

yes but this just for updat

[grinovsky]

device is silent=device no responding=device is blocked

[gtmech]

my frend i have ine 15v 500ma is it good ??

I use 12v 2amp power pack for everything, never had any problems ever, i plug the same power pack into the upa and xprog-m.