Vectra C

[gurmk]

Tried to programme key with Tech2Win
Inserted un-programmed key, switched the ignition on when prompted, then it says please wait, after few seconds it says switch the ignition on but the ignition is already on.
1 fault code B3601: Key Capture Relay. Any idea what or where it is?
Any help will be greatly appreciated.

[P&D]

Have a look here might point you in the right direction

Hidden cause (http://www.aftermarketonline.net/Technical/2013/28370-/Hidden-cause)

[amrif]

link is dead, can someone renew? I have the same problem after CIM replacement.

[P&D]

link is dead, can someone renew? I have the same problem after CIM replacement.

Not sure if this will help you but might do

http://www.digital-kaos.co.uk/forums/showthread.php/264961-Vectra-C-CIM-problem