How to read sirius 32

[garabounga]

Hallo guys
I would like to read a sirius 32 from a 2000 clio 1.4 for immo issues itryed with galletto 1260 but some how i doesnt read i think because the immo is on tyed in another clio it reads no problem. ihave fvdi en xprog if someone can help with how to read on bench it wil be very nice

thank to all

[DashProg]

You just desolder the 29f and you read it on the bench

[stefaudio]

Yes open ECU and read AM29F200BB with programmer(Willem,TL866)

[garabounga]

ok thnx en with fvdi i dont have willem i only have xprog en fvdi

[bangreno]

TL866 is verry stable for this chip , with adapter

[Shmortz]

willem is also very good old programmer, I use one from 10 years, it is very good for many eprom and flash used in many ECU's and it's very cheap...

[garabounga]

ok thnx do u khnow where i can order one ?

[pandokrator]

read it with galletto on boot mode flash
bR

[garabounga]

read it with galletto on boot mode flash
bR

thanx i have only galletto 1260 is it possible with this one i can read it on the car but i have only 64kb flash memory

[garabounga]

En do you have de pinouts from the OBD cable galletto 1260 to ecu ? like from the obd pins to ecu .

Thnx a lot

[pandokrator]

pin of ecu is the same for any obd connector,
use any obd cable with wires connected to ecu pin or just a simply wires
for connect your 1260 use :
pin 7 galletto ---- pin 56 ecu
pin 16 galletto ---- pin 29 & 30 ecu == +12V
pin 4 & 5 galletto ---- pin 3 ecu == GND

pin 28 on Flash ground it with one resistor 1K --- give power to ecu --- remove GND from resistor ---
read data with 1260 --- ;-)
same procedure for read - writing
bR

[kohli]

you can use willem

[garabounga]

pin of ecu is the same for any obd connector,
use any obd cable with wires connected to ecu pin or just a simply wires
for connect your 1260 use :
pin 7 galletto ---- pin 56 ecu
pin 16 galletto ---- pin 29 & 30 ecu == +12V
pin 4 & 5 galletto ---- pin 3 ecu == GND

pin 28 on Flash ground it with one resistor 1K --- give power to ecu --- remove GND from resistor ---
read data with 1260 --- ;-)
same procedure for read - writing
bR

thnx for thr info

[garabounga]

thanx to all of corse :burnout:

[lekingabs]

programmer more best

[prusony]

Piasini read on K-line Sir-32..

[CentralinasPt]

Beeprog is the best :)



Put Thanks ;)

[prusony]

Yes, Beeprog COOL programmer (i have) ....
But to Piasini no need use soldering station ... :)

[CentralinasPt]

Tomorrow I will test with piasini , I work with this smok for this ecu

[dadal]

read it with galletto on boot mode flash
bR
it is my first self made diagram, nice to see it here on DK :)

[danielif]

Renault CAN/K-line ECU Tool read on K-Line or CAN.
Greet tool.