Remote Key for Citroen Jumper 2009

[joolsik]

Hi friends,

can someone tell me where I can order remote key for Citroen Jumper 2009?? It doesnt have to be original... It can be also fully functional key from china.... Price is important for customer.

Thank you very much

[autochei]

from china no exist but u can find sh

[coolsoda]

3DGroup have the aftermarket ones

361663


apollo auto have cheap genuine key $42
https://www.apollo-auto.com/products-categorized-by-make/fiat/fiat-f500-3b-remote-key-433mhz-genuine-and-brand-new

[Atex31]

That's for a Citro?n Relay.

The Citro?n Jumper is a Citro?n Dispatch.

[coolsoda]

Citroen Relay is Jumper
Dispatch is Jumpy

[Atex31]

Are they both based on the Renault Kangaroo?

[smokey08]

The Jumper is fiat based with a ford transit (puma) engine.

[Atex31]

I know,

It was a Kangoo joke! :)

[joolsik]

So... Adapting key with AVDI was no problem, but I am not able to adapt remote control... Key should be ok...
If I want to connect do BCM to learn remote control with AVDI: I write the pin, it is accepted, but after a while I get answer: negative response. Any hint on this?

[godfathertre]

IF KEY ADAPTED THE REMOTE SHOULD WORK CITROEN and PEUGEOT TOO MANY DIFFERENT TYPES OF REMOTE KEYS and also if cheap chinese keys half of the times do not work only the immobiliser part of key works better cloning key and adding a cheap

remote locking kit or buy good quality remote.

[joolsik]

I know... I already have some chinese crap where remote control doesnt work at all...

I just want to know right procedure how to adapt remote for Citroen Jumper with PCF7946
1) First adapt immo and then remote control? or
2) Adapt just immo and then remote control will work too?? Its normal for PCF7946....

Another thing is that AVDI dont even let me to adapt remote control.... When I try to start the procedure of learning... it writes negative error immediately...

[kevfield]

Remote is programmed when precoded from bcm dump then add key with pin by obd..
There is no remote programming procedure , thats if its a PCF7946

Thanks Kev

[joolsik]

Yeah... I thought too... I precoded the key with avdi... added key with pin by obd... Transponder is PCF7946. I dont know whats wrong... Ok.. Thank you!


Remote is programmed when precoded from bcm dump then add key with pin by obd..
There is no remote programming procedure , thats if its a PCF7946

Thanks Kev

[baken]

I know... I already have some chinese crap where remote control doesnt work at all...

I just want to know right procedure how to adapt remote for Citroen Jumper with PCF7946
1) First adapt immo and then remote control? or
2) Adapt just immo and then remote control will work too?? Its normal for PCF7946....

Another thing is that AVDI dont even let me to adapt remote control.... When I try to start the procedure of learning... it writes negative error immediately...
If you precode 7946(not 7936 , because their precoding procedure is different than each other) , probably key is wrong
There are 2 type key, magnetti marelli or delphi- you have to use magnetti marelli key. Maybe you used delphi ? so it is not compatible with this car.

SM-G920F cihazımdan Tapatalk kullanılarak g?nderildi

[reks13]

No, just need add some data from dump of bsi, rsk low, hi and rcfg