Log in

View Full Version : Steering Angle Sensor internal code Toyota prius 850 degrees stuck



BestElectrical
31st January, 2017, 09:44 PM
Hello, could somebody clear the internal code from this steering angle sensor?
Thank you,

PN: 89245-74010
Chip: 93c66
425219

gttuning
31st January, 2017, 10:00 PM
Hello, could somebody clear the internal code from this steering angle sensor?
Thank you,

PN: 89245-74010
Chip: 93c66
425219
I dont think so.some things have to be fix properly

Sent from my SM-G935F using Tapatalk

BestElectrical
31st January, 2017, 10:06 PM
I dont think so.some things have to be fix properly

Sent from my SM-G935F using Tapatalk

Somebody took the wheel off to check the clock spring and turned the steering angle sensor more than 850 degrees so it is now stuck at 850. I have seen some people remove that code from dump and steering sensor worked after that fine. There is no problem with the sensor.
Thank you,
BE

repairmymodule
1st February, 2017, 02:32 AM
You can try to remove the 4 bytes after "aa 55" in line 80

BestElectrical
1st February, 2017, 03:32 AM
You can try to remove the 4 bytes after "aa 55" in line 80

Thanx, after writing back I scan it has a same code, and still have 850 degrees stuck.

Any other Ideas?
Thank you

repairmymodule
1st February, 2017, 03:41 AM
My last guess would be to also clear out the data in line A0 after the 2 bytes "aa 5a"

Sorry I can't be more helpful,

Good luck!

BestElectrical
1st February, 2017, 04:53 PM
Any other ideas?

Brayn
1st February, 2017, 05:05 PM
Yes can reset and corect errors

Sent from my F3216 using Tapatalk

slgs
1st February, 2017, 07:41 PM
Can you solve the problem ?

BestElectrical
2nd February, 2017, 05:34 AM
Yes can reset and corect errors

Sent from my F3216 using Tapatalk



Please do.

Thank you

PierreTheron
2nd February, 2017, 07:16 PM
Or just use original dump and set the angle sensor closer to zero while cheking it on diagnostics

BestElectrical
2nd February, 2017, 09:48 PM
Or just use original dump and set the angle sensor closer to zero while cheking it on diagnostics

With original dump it is always showing 850.5 degrees. Even when it is straight at 0 degrees. Toyota sensors have a specific range, if exceeded that range the sensor writes error code inside eeprom and stops working. When the sensor is connected in the car and somebody is checking if the clockspring is good, they go over the range with a good clockspring killing the sensor.

repairmymodule
3rd February, 2017, 03:01 AM
Is it possible that the steering angle sensor physically broke, like how a clock spring can break by over turning? I have never taken a steering angle sensor apart on a Toyota before

BestElectrical
3rd February, 2017, 08:57 PM
Is it possible that the steering angle sensor physically broke, like how a clock spring can break by over turning? I have never taken a steering angle sensor apart on a Toyota before

Hi, Clockspring max turn on toyota usually around 900 degrees one way.
Steering angle sensor max turn is less than 850 degrees. that is where the problem starts.

FxShaw
4th February, 2017, 12:21 AM
I fixed some before but older ones, none with 93c66 so far.
I don't have a clue on this one.. what year is this prius?

BestElectrical
4th February, 2017, 01:37 AM
I fixed some before but older ones, none with 93c66 so far.
I don't have a clue on this one.. what year is this prius?


Its a 2012 prius

FxShaw
4th February, 2017, 01:44 AM
Its a 2012 prius

Weird...I never done a prius one before but I did a 14 camry and a lexus and both had a 24c02
Would of never figure a prius is so advance on a SAS sensor lol.

janushaan
4th February, 2017, 04:45 AM
jump 4 and 13 on obd port for few minutes with ignition on

janushaan
1st March, 2017, 04:54 AM
Weird...I never done a prius one before but I did a 14 camry and a lexus and both had a 24c02
Would of never figure a prius is so advance on a SAS sensor lol.

have you actually fixed the lexus I have got 2013 lexus rx350 with sas internal code and stuck at 840 doesnt move,, is there any solution is the chip in the clock spring,, never hve done these ones

SoftDump
7th April, 2017, 12:11 PM
89245-30110


89245-74010, 89245-74020 i can

Brayn
7th April, 2017, 12:18 PM
I can do toyota any steering angle inside have 93C66 and 24c02 ....😉

Sent from my F3216 using Tapatalk

khching2003
7th April, 2017, 02:32 PM
solve problem already?

SoftDump
9th April, 2017, 06:52 PM
LEXUS
GX460
89245-30110
24C02


LEXUS
IS250
89245-30110
24C02


LEXUS
RX350
89245-30110
24C02


LEXUS
RX450
89245-30110
24C02


LEXUS
RX450H
89245-30110
24C02


TOYOTA
HILUX
89245-30110
24C02


TOYOTA
LC PRADO 150
89245-74010
93C66


TOYOTA
PRIUS
89245-74010
93C66


TOYOTA
ALION
89245-74020
24C02


TOYOTA
LC PRADO
89245-74020
24C02


TOYOTA
MARK X
89245-74020
24C02


TOYOTA
PREMIO
89245-74020
24C02


TOYOTA
PRIUS
89245-74020
24C02


TOYOTA
WISH
89245-74020
24C02


TOYOTA
VENZA
89245-0T010
93C66

SoftDump
9th April, 2017, 06:54 PM
write to private who have problem

kredka74
22nd November, 2017, 05:13 PM
Hi SOFTDUMP!
Could U help me with prado sensor 89245-74010?
How can i set small gears?
i test clear bin but not working!
PayPal avail
Regards:
Bob

Brayn
23rd November, 2017, 07:39 AM
Hi SOFTDUMP!
Could U help me with prado sensor 89245-74010?
How can i set small gears?
i test clear bin but not working!
PayPal avail
Regards:
Bob

:2in1:
softdump have Already Banned

kredka74
23rd November, 2017, 06:03 PM
Have U any contact with softdump?

hexguru
23rd November, 2017, 07:35 PM
post your origianal dump and ill clear, your dumps cleared not right

kredka74
24th November, 2017, 11:42 AM
HI! Thanks!
I posted wrong file!
there is ori.

Regards:
Bob

hexguru
24th November, 2017, 11:14 PM
pass in pm , if the error does not go away, do 2 sensor turns and write again , when the sensor will work connect the diagnosis and set the angle 0,

then without moving the positions of the magnets, rearrange the central gear in the position corresponding to zero then in the wheel position straight


assemble the steering.


Do not forget to put the spiral in the center position

kredka74
25th November, 2017, 12:16 PM
Ok, all done by myself! I found algo for clear!
Thank U hexguru anyway!
Regards:
Bob

khching2003
7th December, 2017, 03:05 PM
can sare password ?

wagnov15
2nd January, 2018, 03:28 AM
89245-30110


89245-74010, 89245-74020 i can
please how much the file?

gerardo4r
3rd March, 2018, 04:36 PM
Hi, I have the same problem, could you send me the pass for reset zip file?
Thanks
Gerardo

gcirvini
24th May, 2018, 03:38 PM
can anyone share it on mega, i do not have download privileges. Thanks
*Read the rules mate,please !!

TariqHusban
24th June, 2018, 05:25 PM
Dear SoftDump

Please help me to solve prius steering angle sensor 89245-74010

Chongcheeluan
30th July, 2018, 06:36 AM
89245-30110


89245-74010, 89245-74020 i can
hi mate can u help

amlgarA
30th July, 2018, 06:24 PM
your file fixed...

QUYNHONTOYOTA
18th August, 2018, 04:11 AM
Thank!
Can share password ?

QUYNHONTOYOTA
18th August, 2018, 04:11 AM
your file fixed...
Thank!
Can share password ?

QUYNHONTOYOTA
18th August, 2018, 04:12 AM
pass in pm , if the error does not go away, do 2 sensor turns and write again , when the sensor will work connect the diagnosis and set the angle 0,

then without moving the positions of the magnets, rearrange the central gear in the position corresponding to zero then in the wheel position straight


assemble the steering.


Do not forget to put the spiral in the center position
Thank!
Can share password ?

gcirvini
8th September, 2018, 01:41 PM
Ok, all done by myself! I found algo for clear!
Thank U hexguru anyway!
Regards:
Bob
Dou You Have The bad and good file, can you share them both, I have a good one that I used to fix a prado 150 that has the 89245-74010 but i want to know how to fix them, I can fix the ones that have the 24C02A mem.

gcirvini
8th September, 2018, 02:00 PM
Look for my video online on youtube

https://www.youtube.com/watch?v=ajP62XJf80I Its in spanish

Here are the files that i have. I dont know why but sometimes I have to edit the corrupted file because the one I have that works doesn't. For example Here in Argentina The Hilux Pickup (Known as VIRGIN in the US) has the 89245-0k010 and the Hilux SW4 SUV has the same angle sensor, but i got error using the file that i use with the Hilux Pickup and had to fix the one that i read from the SW4 in order to make it work.

Sharing my knowledge for free and happy to help anyone, please share yours!

ecumiuru
16th December, 2018, 07:11 PM
hello dr,
how to download this file? please give me a file

Kia1326
25th August, 2019, 11:22 AM
645557Hi everyone if you can help me how to program string angel plesae

dshimkute
8th March, 2021, 04:00 AM
Hello kredka74. Can you shared algo for clear eprom steering angle? I can pay for it. Thanks.

ismili1967
8th March, 2021, 06:48 AM
send your file here and i will clear it for you .

PierreTheron
21st April, 2021, 07:51 PM
wdely spread on net how to fix this .. so no money in it m8 ,,,

mpprii
22nd May, 2021, 03:34 AM
Are there still persons on this thread who assist with resetting steering angle issue? I'm currently in the situation where my angle sensor is stuck at 850.5.

I actually do not know what dump the other guys are talking about or where they got the dump. But if anyone reads this and could instruct me on what to do, I'd be super grateful as nothing I try in techstream allows me to reset or relearn the steering angle

I have a 2014 Toyota Aqua..in US it's called Prius C