nissan micra k13 key coding [Sitemap]

drivesure

10th November, 2018, 10:18 AM

hi good day - have nissan micra 2012 with K13 vin number - bcm have eeprom 93c66 with a pin code 8639 and we code the transponder with tango and the immo light is solid - when trying to read the bcm code with tester it fails - does anyone have another k13 bcm dump i can compare or check the attached dump or any advice on coding procedure - 7936 transponder

regards

lion0304

10th November, 2018, 11:06 PM

Program it by OBD. I've have Juke 2013, program over OBD with fvdi.

AFter programming, led stay solid, no start. Change PCF7936 and led go off.

castin

11th November, 2018, 10:45 AM

Try this file. Tango add key OK.

Brown012

11th November, 2018, 11:18 AM

Did you read the chip as 8bit or 16

castin

11th November, 2018, 12:53 PM

See file name?

autochei

11th November, 2018, 05:45 PM

hi good day - have nissan micra 2012 with K13 vin number - bcm have eeprom 93c66 with a pin code 8639 and we code the transponder with tango and the immo light is solid - when trying to read the bcm code with tester it fails - does anyone have another k13 bcm dump i can compare or check the attached dump or any advice on coding procedure - 7936 transponder

regards

maybe accept only 7946

castin

11th November, 2018, 06:11 PM

maybe accept only 7946

Im add this key, pcf7936 by Tango - ok

lion0304

12th November, 2018, 07:29 AM

maybe accept only 7946

No K13 is only 7936

drivesure

12th November, 2018, 09:07 AM

hi thanks to all for the input - we added key into dump via tango but immo light solid - tried with 7936 on vvdi also and the same result. when coding via tester pin i cannot pull bcm code but in dump the bcm code is 8639. if i code transponder via obd it says incorrect code...does anyone have a k13 micra dump 93c66 so i can compare and see why tester does not pull bcm code. thanks for all the input. only use 7936 and not 7946-remote key.

lion0304

12th November, 2018, 11:14 AM

hi thanks to all for the input - we added key into dump via tango but immo light solid - tried with 7936 on vvdi also and the same result. when coding via tester pin i cannot pull bcm code but in dump the bcm code is 8639. if i code transponder via obd it says incorrect code...does anyone have a k13 micra dump 93c66 so i can compare and see why tester does not pull bcm code. thanks for all the input. only use 7936 and not 7946-remote key.

WHen incorrect code by obd (if you have good pin), that mean maybe ECU problem ( fuse, wirring, power....)