PASSAT B6 ESL FAILURE ,PROBLEMS ON PROGRAMMING

[12manux]

Hi guys.I m working on a 06 Passat b6 1.9 TDI with failure on esl.Basically when i got the car the ignition won t turn on and the yellow steering wheel would come on the dash also no comunication with imobiliser.
I got a used elv from scrap yard,installed.Now the car turn on ignition and i get comunication with immobiliser.I got the pin from engine ecu with FVDI (EDC16U1) ,checked the pin by log in on ecu and the ecu accepted the pin .But when i log in on the adaptation on immobiliser it says pin is not good and i have wait time 250 minutes.
Now the question comes : Can i just swap the MCU or E2P (i don t really know what it has inside) and put it from old esl to "new" esl ? Does all the esl has the same mcu or e2p ? The esl is the same manufactuerer year as the old one.Thanks

[nenadgorgi]

Buy new esl from dealer install in vehicle and adopt with pin code from car use vcds
30 min for installation 5 minutes for programming

[marty35]

nenadgorgi is correct you cant adapt a second hand one only new from dealer .....

[12manux]

I ve seen people adapt second hand units. What about swaping the mcus?

[marty35]

thats making extra work for yourself .... its a 40min job with new esl from dealer......

[brend]

I ve seen people adapt second hand units. What about swaping the mcus?

Don't confuse programming with a detail that's just changed places........730061

[12manux]

Thanks for infos guys (or maybe not). SOLVED by swaping the mcus. Car started right up from first try.


Thanks all for replies.

[ricked]

Thanks for infos guys (or maybe not). SOLVED by swaping the mcus. Car started right up from first try.


Thanks all for replies.

next time make copy with xprog