vw polo strange problem with key help please

[keytech]

vw polo 2007/09 1.4 tdi edc17 dash m.marelli 6Q0920804J MCU 9S12H256 2K78X all key lost, i read the dump ,have pin and try
to programming with magic 2 id48 transponder and have incorrect key programming after i try vw can bus transponder and no luck maybe have CsecurIty can someone check for me please if have CS , THANKS

[lesakljucevi]

vw polo 2007/09 1.4 tdi edc17 dash m.marelli 6Q0920804J MCU 9S12H256 2K78X all key lost, i read the dump ,have pin and try
to programming with magic 2 id48 transponder and have incorrect key programming after i try vw can bus transponder and no luck maybe have CsecurIty can someone check for me please if have CS , THANKS
Pin:7182? No need CS

[brend]

What about key prepare?

Which one tool you use for this job?

[keytech]

thanks i have the pin , i have calculate pin with avdi dump tool , but can t programming the key ,with vcds, zedfull, sbb ,etc

[keytech]

i read the dash with enigma ,maybe something wrong in dash?

[lesakljucevi]

VVDI2 can do chip from dump direct

[lupu_sandu]

Enter PIN>wait 20 min>Adaptation>Done

[keytech]

Hi thanks to all ,in this case i produce transponder with tango by the dump, after programming in car and start ok ,its need to write some ID IN transponder similar to CS

[brend]

Like I said in post 3, first need key prepare then programming and for this job need good key tool not diagnostics equpment.


Hi thanks to all ,in this case i produce transponder with tango by the dump, after programming in car and start ok ,its need to write some ID IN transponder similar to CS