Scanning on a 7025

[comfysofa]

Hi - this is my first post. So, hello to all and if anyone does, thanks for the help.

I have a 7025 which now for some reason will not scan - ive narrowed it down to the frequency - if i scan with the frequency ive always used (443) i get just 10 channels (im in the 6952 area). So, it seems to be dependant on that. If i change that value i either get no channels or just a few....so, does anyone know the magic frequency?? been randomly trying for a couple of weeks now with no luck. If anyone could put their 2 cents in that'd be great!!

[Grizzly171]

Hi their, goto menu/setup/service searching/manual scan.

Make sure you have tuner on DVB-C and use these settings.

Frequency : 755
Inversion : Auto
Symbol Rate : 6952 ( Old T/west )
Modulation :64-QAM
FEC : Auto
Network Scan : Yes

This should get you the chanels.

You can also try doing a auto scan as well.

Hope this helps.

[comfysofa]

No - no luck - its all definately working as i have 600 which is working fine....strange. as i say if i leave it on 443 i get just 10 channels...

[comfysofa]

Oh - what image are you using - ive tried a LT image and also currently gemini 4.2 - however as i said both of these were ok....this only happened a month or so back...

[on_the_jazz]

You need to add 6952 as an additional sr to your tuner config, and then do an automatic scan. I don't think single frequencies can be relied upon any longer.

[comfysofa]

Close - but no, got 12 channels that time......if i leave the frequency on 466....thanks for that extra bit of info though....

[kwasiarsenal]

I have the same prob with my dm7025+ and it seem not to scan manually anymore, but with the freq steps set to 01000 and a complete scan I suceeded. Hope it helped

[comfysofa]

Thats it!!! - its scanning - thanks very much - i really was beginning to loose hope then.

This might be best put on as a sticky as i expect im/we're not the only people with 7025's

Again - thanks very much.