Blade_Quad Image and Network settings???

[tosser2]

Hi all

I just flashed my box with the above image and am now unable to setup the network settings on the box!!

Each time I set the box to DHCP-ON and re-start the box DHCP is back OFF again! I am also unable to manually set the IP address as each time I restart the box it has reset itself to some unheard of IP address!!

Anyone seen this before? If so what am I doing wrong please??

Thanks in advance.

[standarren]

bad flash reflash the image

[plasterer]

After you Change settings of the box
You need to push restart network
After that the ip will change and stay
Make sure dhcp is disabled ..............Paul

[bob114]

hi

this has happened to me no network on start up
do as plasterer post
and check network in set to on and not off at start up

hope this may help

[tosser2]

Tried this and no joy - will try commando tonight!!

Thanks for the help!

hi

this has happened to me no network on start up
do as plasterer post
and check network in set to on and not off at start up

hope this may help

[smoggie]

hi, if using the commando image use the magic files from here h**p://www.mercs.us/Tools.htm

[tosser2]

Thanks I got them!!

hi, if using the commando image use the magic files from here h**p://www.mercs.us/Tools.htm

[mini]

Mr Habibi, like many people have said stick to one thread. You keep posting all over place and its getting annoying. You can't have read posts otherwise you would not be asking the same question time and time again. What you need you can find at>>>>
***.mercs.us

http://www.digital-kaos.co.uk/forums/downloads/guides/5/how-flash-dbox-only-serial-cable-223/

http://www.digital-kaos.co.uk/forums/downloads/guides/5/ifa-guide-114/

see all you have to do is look in the download section and you will find what you need. All you have to do is a bit of reading, then if your stuck make your own thread. Theres no point posting all over the place coz you will get confused.