Hi all.
I guess i`m the only man in universe with this problem:
my DB7000s was working fine with diseq,then i put it on motor and also worked fine,i could communicate with DB via FTP,upload,edit lists... Now i moved away and i put it again on diseq.
Also works fine except one small problem, i can`t connect to DB via crossover cable annymore. When i try to connect with FlashWizardPro i says "unable to establish connection,check connection parameters" but i haven`t changed anything on DB since last time i used FWpro,and it worked fine back then... i tried to change IP adresses few times,same answer...pinged laptop and it was ok,pinged DB an it says destination host unreachable.
Any suggestions for step nr.1? i have crossover cable, i`ll have null modem cable in a few weeks(no shop on the island) and i can connect DB with ethernet cable(if it helps).
I guess i`m the only man in universe with this problem:
my DB7000s was working fine with diseq,then i put it on motor and also worked fine,i could communicate with DB via FTP,upload,edit lists... Now i moved away and i put it again on diseq.
Also works fine except one small problem, i can`t connect to DB via crossover cable annymore. When i try to connect with FlashWizardPro i says "unable to establish connection,check connection parameters" but i haven`t changed anything on DB since last time i used FWpro,and it worked fine back then... i tried to change IP adresses few times,same answer...pinged laptop and it was ok,pinged DB an it says destination host unreachable.
Any suggestions for step nr.1? i have crossover cable, i`ll have null modem cable in a few weeks(no shop on the island) and i can connect DB with ethernet cable(if it helps).
Comment