i am trying to flash a box throuh ethernet but i dont i am getting a connection. are some boxs a bit tempremental and dont work. shall i try it with a nullmodem?
no local area connection
Collapse
X
-
-
go to control panel > network connections
select your network card that your using and go to properties.
click configure and find the bit that says "link speed and duplex" or similar. change this to 10mbit/half duplex.
also click on "internet protocol (TCP/IP)" and assign an IP address (something like 192.168.0.100)
ignore the dns stuff.
also make sure your using a crossover cable. you can check by looking at the colours of the wires where they go into the plugs. they should be in a different order at each end.Comment
Comment