Finds Transponders - No Channels

[toffeeman]

I have a Dbox2 (1x) which was working with Andromeda 2 image until it just stopped.

I can scan and find all transponders but it never finds any channels.

Even paid for a new tuner from Germany and got it fitted to no avail.

Any ideas?

[plasterer]

Push red then Blue
Wots the signal levels
Does it give waiting for time ERROR
Is the LCD Clock Wrong .......Paul

[toffeeman]

Looks like my signal is zero, line tested by reconnecting VM box back in and FTA channels are present.

Clock is wrong too...

[toffeeman]

Spot on too with the 'Waiting for time...Error' as well...

Guess you've seen this scenario before!

[plasterer]

Its all heading in the same Dirrection mate
If you transfer Working Service and bow k s from one to the other
It should work the Same
Even back up image of the same chiptype
This with waiting for time is looking like a Poss tuner Chip fault
Are you getting free to air on D Box .......Paul

[toffeeman]

I don't get anything - this is what prompted me to buy a new tuner board for my dbox which I had to get someone handy with a soldering iron to remove the old tuner and fit the new one!

The messages I get are the same as before my tuner swap out which makes me wonder if the problem lies elsewhere?

[MetMan]

Looks like my signal is zero, line tested by reconnecting VM box back in and FTA channels are present.

Clock is wrong too...

read the snr not the signal is it above 55000

[toffeeman]

My SNR is 27368, BER is 6060 and SIG is 61824, Bitrate 0

[MetMan]

My SNR is 27368, BER is 6060 and SIG is 61824, Bitrate 0

ur snr has to be over 55000 unless no channels i'm afraid....

[clapton64]

I had the same problem with a dbox.
I bought another one and abandoned the old one.
I was bored one day and got the old box and flashed it with the blade quad image and hey presto all was well.
It used to say waiting for time and the clock was stuck at 1.00.
Try flashing it again, it worked for me.
The box is still running well.
Hope this helps.

[toffeeman]

Cheers Everyone, I will attempt a reflash with Blade Quad and post results!

[toffeeman]

Flashed box with Blade Quad still same problem.

How can I increase my SNR value to above 55000?

[toffeeman]

I reflashed the Andromeda 2 1x image and copied the new nagrarom7, deleting the old rom 7, 10 & 11 files.

Restarted the emu and rescanned - all channels back and I'm up & running again!