setanta freq

[davieboy.rfc]

hi im in the gasgow area & was wondering if any of u guyz ot there knew the freq for my area any help apprec.

[dank76]

YOU SHOULD PICK UP ON A FAST INSTALL SCAN. MINE JUST WORKED

[davieboy.rfc]

i have all the setanta channels but they r the only ones that r breakin up ive poor coverage in my area appar .an ideas?

[dank76]

TRY DOING AN MANUAL SCAN ON EACH SETANTA CHANNEL IT MIGHT FIX PROBLEM ?

[PVR5000]

hi im in the gasgow area & was wondering if any of u guyz ot there knew the freq for my area any help apprec.

I had the same problem. I found that if you scan your channels and then manually sort them it works. If you are using cdf file then it will lose again.

[bluefin]

347,000 MHz if that any good m8

[davieboy.rfc]

i did a manaul scan on the channels bt still the same breakin up ive been told that i mite need a signal booster or a higher annulator as im using a 8db one at the moment .

[davieboy.rfc]

set freq

347,000 MHz if that any good m8

ye m8y my freq is set at 347.000 im just in a crap area for that partic freq.



ps. cmon the gers for sat

[Fergal]

i did a manaul scan on the channels bt still the same breakin up ive been told that i mite need a signal booster or a higher annulator as im using a 8db one at the moment .

Try it without the 8db attenuator

[davieboy.rfc]

i will give it a go m8y .

[davieboy.rfc]

hi m8y i took out the attenuator & did a manual scan on setanta & no joy must need a signal booster, but up until vm messed aboot with the signal the setanta channels were fine.