max v channels??????

[pezmaz]

I have followed the instructions on here to load firmware and channels but at the end of the scan i get no channels and the receiver says 0000.I have used the standard and 8% download with the same result.
All i get on the screen is 'channel not available'

[camelv]

do a factory reset m8 then a power scan also make sure you are selecting the right symbol rate.
if you get stuck check this sticky.

http://www.digital-kaos.co.uk/forums/f71/guide-eurovox-scanning-settings-9789/

[pezmaz]

Thanks Camel
I have done that using the instructions(Telford 6952).
No change.
As the scan operates it is showing steps scanned in the left hand top eg: 7/780 but the receiver is still on 0000 and i cannot seem to get anything through the telly

[camelv]

Thanks Camel
I have done that using the instructions(Telford 6952).
No change.
As the scan operates it is showing steps scanned in the left hand top eg: 7/780 but the receiver is still on 0000 and i cannot seem to get anything through the telly

what f/ware have u put on your box and what max v is it m8.

[pezmaz]

it's the max v 2008 and i have the 8% firmware installed.
I have managed to get about 70 channels now but don't know why no more.The picture is considerably worse than through my cable box as well

[camelv]

the 8% is only a signal fix have u flashed it with evox max v firmware.

http://www.digital-kaos.co.uk/forums/f71/new-max-v-ex5000-autosort-fix-051208-a-18045/

[pezmaz]

yes i have

[camelv]

i suggest you try reflash and see what happens

[pezmaz]

Thanks Camel.
Should the picture quality be the same as through my standard cable box?--it isn't at the moment