I Downloaded The *NEW* EX7000HD Firmware 12/03/09, And When I Flashed he Box I Did A full Factory Reset And a Deep Scan. But When the Scan Finishes I'm Not Getting Half As Many Channels As I Was Previous. I Have Re Scaned Many Times And still the Same? Im In Dublin On NTHELL, If Anyone has any suggstions?
-
-
Dublin and other parts of Ireland are losing channels due to an encryption changeover. However you should not be losing half your channels as of yet.
Do a factory reset and scan on the correct symbol rate from the direct feed. If you are using a splitter take it out for the initial scan. Should be no need for a deepscan.
A powerscan using 6887 as your SR and start at 290.00Mhz end at 420.00Mhz should be sufficient.I refuse to answer that question on the grounds that I don't know the answer. - Douglas Adams -
will channels be permanently lost due to encryption changeover,or just temporary? also when i do just a power scan it only finds 9 main signals where it used to find 13! i have 3 Eurovox max in the house and there all running perfectly!Comment
-
Also in Dublin ntlhell have deep scanned and got back most channels but lots are coming up scrambled
Comment
Comment