I have just acquired a new eurovox ex1000sl from eurovox.org and attempted to set it up after flashing with the UFL_EX1000SL_v1-0_DarX firmware. I followed the instructions in Hiteck's flashing instructions. As i had the null cable there was no problem detecting the port and downloading and installing the firmware. When completed i followed the instruction in the Hitecks scanning guide The box came with a null cable which my PC detected. I completed the full scan and over 700 tv and radio stations were detected (I live in Londons, Camden area).
When attempting to connect to a channel i get the "Please wait, code being updated.." message. I waited for all of 10 hours when i fell asleep but woke up to the same message. I flashed on 3 more occassion to no avail. I also read something about reseting the button on the motherboard. I've tried that twice and reflashed. No difference.
The system config states:
Model DVB-XC BoxS TDA
S/W Ver 1.0 ST4 Aug 22 2008
H/W Ver 2.0tS
Bootstrap v001
S/W Build Kuro
Clearly the firmware is not upgrading even though it states that it is completed with no error message. I've also read the thread about flashing problems however i don't think the situation is the same as i have no problem detecting the com port. Is there something obvious i have missed as I don't particularly want to do down the inputting codes route.
I was trying to avoid buying a clone by using what i hope is a legitimate site. Any help would be appreciated.
When attempting to connect to a channel i get the "Please wait, code being updated.." message. I waited for all of 10 hours when i fell asleep but woke up to the same message. I flashed on 3 more occassion to no avail. I also read something about reseting the button on the motherboard. I've tried that twice and reflashed. No difference.
The system config states:
Model DVB-XC BoxS TDA
S/W Ver 1.0 ST4 Aug 22 2008
H/W Ver 2.0tS
Bootstrap v001
S/W Build Kuro
Clearly the firmware is not upgrading even though it states that it is completed with no error message. I've also read the thread about flashing problems however i don't think the situation is the same as i have no problem detecting the com port. Is there something obvious i have missed as I don't particularly want to do down the inputting codes route.
I was trying to avoid buying a clone by using what i hope is a legitimate site. Any help would be appreciated.
Comment